Scan Tool Data Definitions

2005 Chevrolet Equinox FWD V6-3.4L VIN FSECTION Scan Tool Data Definitions


Scan Tool Data Definitions
Body Control Module (BCM)
Battery Voltage
Display indicates battery voltage. Measured in volts.
Brake Apply Sensor
Display indicates brake apply sensor voltage. Measured in volts.
Ignition 1
Display indicates ON when the ignition 1 input circuit of the module receives a battery signal from the ignition switch.

Powertrain Control Module (PCM)
TCC Brake Switch
Displays ON or OFF status of the TCC Brake switch.
TR Sw. A/B/C/P
Displays LOW or HI for the state of each of the 4 inputs from the IMS. LOW displayed indicates a low voltage signal (0 volts) being monitored at the PCM. HI displayed indicates a high voltage signal (B+) being monitored at the PCM.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.