Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005EQUINOX FWD V6-3.4L VIN FREPAIR AND DIAGNOSISTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGINFLATABLE RESTRAINT SENSING & DIAGNOSTIC MODULE - PROGRAMMING AND SETUP
2005 Chevrolet Equinox FWD V6-3.4L VIN F
Inflatable Restraint Sensing & Diagnostic Module - Programming and Setup
2005 Chevrolet Equinox FWD V6-3.4L VIN FSECTION Inflatable Restraint Sensing & Diagnostic Module - Programming and Setup
INFLATABLE RESTRAINT SENSING AND DIAGNOSTIC MODULE PROGRAMMING AND SETUP
The replacement of the inflatable restraint sensing and diagnostic module (SDM) will require that the SDM part number be relearned by the body control module (BCM). The following procedures are designed to setup the SDM correctly and must be performed.
IMPORTANT:
- The Air Bag indicator may illuminate and DTC B1001 may set during the BCM reprogramming procedure.
- Use the 10-minute relearn procedure when programming the theft deterrent system.
1. Program the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration in Computer/Integrating Systems.
2. Program the theft deterrent system. Refer to Programming Theft Deterrent System Components in Theft Deterrent.
3. Clear any DTCs.
4. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.