Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005EQUINOX FWD V6-3.4L VIN FREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINEINTAKE MANIFOLD
2005 Chevrolet Equinox FWD V6-3.4L VIN F
Intake Manifold
2005 Chevrolet Equinox FWD V6-3.4L VIN FSECTION Intake Manifold
Lower Intake Manifold Bolt - Center
First Pass 7 Nm (62 inch lbs.)
Final Pass 13 Nm (115 inch lbs.)
Lower Intake Manifold Bolt - Corner
First Pass 13 Nm (115 inch lbs.)
Final Pass 25 Nm (18 ft. lbs.)
Upper Intake Manifold Bolt/Stud 25 Nm (18 ft. lbs.)
Throttle Body Bolt/Stud 10 Nm (89 inch lbs.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.