Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005EQUINOX FWD V6-3.4L VIN FREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULETESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESSCAN TOOL DATA DEFINITIONS
2005 Chevrolet Equinox FWD V6-3.4L VIN F
Scan Tool Data Definitions
2005 Chevrolet Equinox FWD V6-3.4L VIN FSECTION Scan Tool Data Definitions
SCAN TOOL DATA DEFINITIONS
Battery 1: The scan tool displays 0-25.5 volts. The state of the battery voltage supplied to the body control module (BCM).
Driver Door Switch: The scan tool displays the status of the driver door switch.
Ignition 1 Input: The scan tool displays the state of the ignition 1 Run/Crank input to the BCM.
Ignition 2 Input: The scan tool displays the state of the ignition 2 Acc/Run input to the BCM.
Ignition 3 Input: The scan tool displays the state of the ignition 3 Run input to the BCM.
Key In Ignition: The scan tool displays Yes/No. The BCM receives an input from the ignition switch indicating whether the key is in the ignition or not, with Yes meaning the key is in the ignition.
Liftgate Ajar Switch: The scan tool displays the status of the liftgate switch.
Pass Door Switches: The scan tool displays the status of the passenger doors switches.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.