Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005BLAZER 4WD V6-4.3L VIN XREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSAIR TEMPERATURE SENSOR ( AMBIENT / INTAKE )SERVICE AND REPAIR
2005 Chevrolet Blazer 4WD V6-4.3L VIN X
Air Temperature Sensor ( Ambient / Intake ): Service and Repair
2005 Chevrolet Blazer 4WD V6-4.3L VIN XSECTION Service and Repair
INTAKE AIR TEMPERATURE (IAT) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Disconnect the intake air temperature (IAT) sensor harness connector.
3. Remove the IAT sensor by pulling straight out using a rotating motion.
INSTALLATION PROCEDURE
1. Install the IAT sensor by gently pushing the sensor into the air cleaner outlet duct until seated.
2. Connect the IAT sensor harness connector.
3. Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.