Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2004TAHOE 4WD V8-5.3L VIN TREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSVEHICLE SPEED SENSORSERVICE AND REPAIR
2004 Chevrolet Tahoe 4WD V8-5.3L VIN T
Vehicle Speed Sensor: Service and Repair
2004 Chevrolet Tahoe 4WD V8-5.3L VIN TSECTION Service and Repair
Vehicle Speed Sensor (VSS) Replacement
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting
2. Disconnect the vehicle speed sensor (VSS) electrical connector (2).
3. Remove the VSS bolt (2).
4. Remove the VSS (1).
5. Remove the O-ring seal (3).
Installation Procedure
1. Install the O-ring seal (3) onto the VSS (1).
2. Coat the O-ring seal (3) with a thin film of transmission fluid.
3. Install the VSS (1).
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the VSS bolt (2).
^ Tighten the bolt to 11 Nm (97 inch lbs.).
5. Connect the VSS electrical connector (2).
6. Lower the vehicle.
7. Refill the fluid as required.
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting
2. Disconnect the vehicle speed sensor (VSS) electrical connector (2).
3. Remove the VSS bolt (2).
4. Remove the VSS (1).
5. Remove the O-ring seal (3).
Installation Procedure
1. Install the O-ring seal (3) onto the VSS (1).
2. Coat the O-ring seal (3) with a thin film of transmission fluid.
3. Install the VSS (1).
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the VSS bolt (2).
^ Tighten the bolt to 11 Nm (97 inch lbs.).
5. Connect the VSS electrical connector (2).
6. Lower the vehicle.
7. Refill the fluid as required.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.