Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2004TAHOE 4WD V8-5.3L VIN TREPAIR AND DIAGNOSISBODY AND FRAMESEATSSERVICE AND REPAIRMODULE REPLACEMENT - SEAT CLIMATE CONTROL - FRONT SEAT
2004 Chevrolet Tahoe 4WD V8-5.3L VIN T
Module Replacement - Seat Climate Control - Front Seat
2004 Chevrolet Tahoe 4WD V8-5.3L VIN TSECTION Module Replacement - Seat Climate Control - Front Seat
MODULE REPLACEMENT - SEAT CLIMATE CONTROL - FRONT SEAT
REMOVAL PROCEDURE
1. Remove the front seat cushion assembly.
2. Disconnect the climate control module electrical connectors.
3. Remove the screw (1) retaining the module bracket to the seat cushion frame.
4. Remove the bracket and module assembly from the cushion assembly.
5. Remove the screws (1) retaining the module (2) to the module bracket (3).
INSTALLATION PROCEDURE
1. Position the module (2) to the bracket (3).
2. Install the screws (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 5 N.m (8 lb in).
3. Position the module and bracket assembly to the seat cushion frame.
4. Install the screws (1).
Tighten the screws to 5 N.m (8 lb in).
5. Connect the climate control module electrical connector.
6. Install the front seat cushion.
REMOVAL PROCEDURE
1. Remove the front seat cushion assembly.
2. Disconnect the climate control module electrical connectors.
3. Remove the screw (1) retaining the module bracket to the seat cushion frame.
4. Remove the bracket and module assembly from the cushion assembly.
5. Remove the screws (1) retaining the module (2) to the module bracket (3).
INSTALLATION PROCEDURE
1. Position the module (2) to the bracket (3).
2. Install the screws (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 5 N.m (8 lb in).
3. Position the module and bracket assembly to the seat cushion frame.
4. Install the screws (1).
Tighten the screws to 5 N.m (8 lb in).
5. Connect the climate control module electrical connector.
6. Install the front seat cushion.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.