Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2004TAHOE 4WD V8-4.8L VIN VREPAIR AND DIAGNOSISWINDOWS AND GLASSRELAYS AND MODULES - WINDOWS AND GLASSPOWER WINDOW CONTROL MODULESERVICE AND REPAIRMODULE REPLACEMENT - REAR POWER WINDOW
2004 Chevrolet Tahoe 4WD V8-4.8L VIN V
Module Replacement - Rear Power Window
2004 Chevrolet Tahoe 4WD V8-4.8L VIN VSECTION Module Replacement - Rear Power Window
MODULE REPLACEMENT - REAR POWER WINDOW
REMOVAL PROCEDURE
1. Raise and support the window glass.
2. Remove the trim panel.
3. Remove the water deflector.
4. Disconnect the window motor electrical connector.
5. Loosen the two window clamp bolts on the regulator.
6. Remove the bolts retaining the window regulator to the door.
7. Remove the module from the door.
INSTALLATION PROCEDURE
1. Install the module to the door.
2. Install the bolts retaining the regulator to the door.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolts to 9 N.m (7 lb ft).
3. Align the window to the regulator, and tighten the clamp bolts.
Tighten the clamp bolts to 9 N.m (7 lb ft).
4. Connect the window motor electrical connector.
5. Install the water deflector.
6. Install the trim panel.
REMOVAL PROCEDURE
1. Raise and support the window glass.
2. Remove the trim panel.
3. Remove the water deflector.
4. Disconnect the window motor electrical connector.
5. Loosen the two window clamp bolts on the regulator.
6. Remove the bolts retaining the window regulator to the door.
7. Remove the module from the door.
INSTALLATION PROCEDURE
1. Install the module to the door.
2. Install the bolts retaining the regulator to the door.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolts to 9 N.m (7 lb ft).
3. Align the window to the regulator, and tighten the clamp bolts.
Tighten the clamp bolts to 9 N.m (7 lb ft).
4. Connect the window motor electrical connector.
5. Install the water deflector.
6. Install the trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.