Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2004MONTE CARLO V6-3.8L VIN KREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYPISTON RING, ENGINE
2004 Chevrolet Monte Carlo V6-3.8L VIN K
Piston Ring, Engine
2004 Chevrolet Monte Carlo V6-3.8L VIN KSECTION Piston Ring, Engine
Piston Ring End Gap
First Compression Ring 0.25-0.46 mm (0.010-0.018 inch)
Second Compression Ring 0.58-0 84 mm (0.023-0.033 inch)
Oil Control Ring 0.254-0.762 mm (0.010-0 030 inch)
Piston Ring to Groove Clearance
First Compression Ring 0.033-0.079 mm (0.0013-0 0031 inch)
Second Compression Ring 40 033-0.079 mm (0.0013-0 0031 inch)
Piston Ring Thickness
First Compression Ring 1.176-1.197 mm (0.0463-0.0471 inch)
Second Compression Ring 1.1476-1.497 mm (0.0581-0 0589 inch)
First Compression Ring 0.25-0.46 mm (0.010-0.018 inch)
Second Compression Ring 0.58-0 84 mm (0.023-0.033 inch)
Oil Control Ring 0.254-0.762 mm (0.010-0 030 inch)
Piston Ring to Groove Clearance
First Compression Ring 0.033-0.079 mm (0.0013-0 0031 inch)
Second Compression Ring 40 033-0.079 mm (0.0013-0 0031 inch)
Piston Ring Thickness
First Compression Ring 1.176-1.197 mm (0.0463-0.0471 inch)
Second Compression Ring 1.1476-1.497 mm (0.0581-0 0589 inch)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.