Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2004MONTE CARLO V6-3.8L VIN KREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCAMSHAFT POSITION SENSORSERVICE AND REPAIR
2004 Chevrolet Monte Carlo V6-3.8L VIN K
Camshaft Position Sensor: Service and Repair
2004 Chevrolet Monte Carlo V6-3.8L VIN KSECTION Service and Repair
CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the coolant recovery reservoir.
2. Remove the drive belt.
3. Disconnect the electrical connector (2) from the camshaft position sensor (1).
4. Remove the camshaft position sensor bolt.
5. Remove the camshaft position sensor from the engine front cover.
INSTALLATION PROCEDURE
1. Install the camshaft position sensor to the engine front cover.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the camshaft position sensor bolt.
Tighten
Tighten the bolt to 10 N.m (89 lb in).
3. Connect the electrical connector (2) to the camshaft position sensor (1).
4. Install the drive belt.
5. Install the coolant recovery reservoir.
REMOVAL PROCEDURE
1. Remove the coolant recovery reservoir.
2. Remove the drive belt.
3. Disconnect the electrical connector (2) from the camshaft position sensor (1).
4. Remove the camshaft position sensor bolt.
5. Remove the camshaft position sensor from the engine front cover.
INSTALLATION PROCEDURE
1. Install the camshaft position sensor to the engine front cover.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the camshaft position sensor bolt.
Tighten
Tighten the bolt to 10 N.m (89 lb in).
3. Connect the electrical connector (2) to the camshaft position sensor (1).
4. Install the drive belt.
5. Install the coolant recovery reservoir.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.