Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2004MONTE CARLO V6-3.4L VIN EREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINEINTAKE MANIFOLD
2004 Chevrolet Monte Carlo V6-3.4L VIN E
Intake Manifold
2004 Chevrolet Monte Carlo V6-3.4L VIN ESECTION Intake Manifold
Lower Intake manifold.
Tighten in sequence to 7 Nm (62 lb in) on the first pass.
Tighten the lower intake manifold bolts (1, 2, 3, 4) in sequence to 13 Nm (115 lb in) on the final pass.
Tighten the lower intake manifold bolts (5, 6, 7, 8) in sequence to 25 Nm (18 lb ft) on the final pass.
Upper Intake Manifold 25 Nm (18 lb ft)
Throttle Body Bolt/Stud 25 Nm (18 lb ft)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.