Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2004MALIBU V6-3.5L VIN 8REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - HVACCONTROL MODULE HVACSERVICE AND REPAIRHVAC SYSTEM - AUTOMATICBLOWER MOTOR CONTROL PROCESSOR REPLACEMENT
2004 Chevrolet Malibu V6-3.5L VIN 8
Blower Motor Control Processor Replacement
2004 Chevrolet Malibu V6-3.5L VIN 8SECTION Blower Motor Control Processor Replacement
BLOWER MOTOR CONTROL PROCESSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the right closeout panel.
2. Remove the blower motor control processor wire harness connector.
3. Remove the blower motor control processor screws.
4. Remove the blower motor control processor.
INSTALLATION PROCEDURE
1. Install the blower motor control processor.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Tighten the blower motor control processor screws.
Tighten
Tighten the blower motor resistor screws to 1.5 N.m (13 lb in).
3. Install the blower motor control processor wire harness connector.
4. Install the right closeout panel.
REMOVAL PROCEDURE
1. Remove the right closeout panel.
2. Remove the blower motor control processor wire harness connector.
3. Remove the blower motor control processor screws.
4. Remove the blower motor control processor.
INSTALLATION PROCEDURE
1. Install the blower motor control processor.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Tighten the blower motor control processor screws.
Tighten
Tighten the blower motor resistor screws to 1.5 N.m (13 lb in).
3. Install the blower motor control processor wire harness connector.
4. Install the right closeout panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.