Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2004MALIBU V6-3.5L VIN 8REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BODY AND FRAMEPEDAL POSITIONING MODULESERVICE AND REPAIR
2004 Chevrolet Malibu V6-3.5L VIN 8
Pedal Positioning Module: Service and Repair
2004 Chevrolet Malibu V6-3.5L VIN 8SECTION Service and Repair
ADJUSTABLE PEDAL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the instrument panel (I/P) closeout panel.
2. Remove the adjustable pedal module 1 from the side of the I/P support beam.
3. Disconnect the electrical connector from the adjustable pedal module.
INSTALLATION PROCEDURE
1. Remove the old 2-sided tape from the I/P support beam.
2. If reinstalling the same adjustable pedal module, install NEW 2-sided tape to the module.
3. Connect the electrical connector to the adjustable pedal module.
4. Install the adjustable pedal module 1 to the side of the I/P support beam.
5. Install the closeout panel.
REMOVAL PROCEDURE
1. Remove the instrument panel (I/P) closeout panel.
2. Remove the adjustable pedal module 1 from the side of the I/P support beam.
3. Disconnect the electrical connector from the adjustable pedal module.
INSTALLATION PROCEDURE
1. Remove the old 2-sided tape from the I/P support beam.
2. If reinstalling the same adjustable pedal module, install NEW 2-sided tape to the module.
3. Connect the electrical connector to the adjustable pedal module.
4. Install the adjustable pedal module 1 to the side of the I/P support beam.
5. Install the closeout panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.