Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2004EXPRESS 2500 2WD V8-6.0L VIN UREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW MOTORSERVICE AND REPAIR
2004 Chevrolet Express 2500 2WD V8-6.0L VIN U
Power Window Motor: Service and Repair
2004 Chevrolet Express 2500 2WD V8-6.0L VIN USECTION Service and Repair
MOTOR REPLACEMENT - POWER WINDOW
REMOVAL PROCEDURE
1. Remove the front door trim panel.
2. Remove the front door water deflector.
3. Remove the electrical connector from the power window motor (2).
4. Remove the nuts (3) that retain the power window motor (2) to the front door module (1).
5. Remove the power window motor (2) from the vehicle.
INSTALLATION PROCEDURE
1. Install the power window motor (2) to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the nuts (3) in order to retain the power window motor (2) to the front door module (1).
Tighten
Tighten the retaining nuts to 11 N.m (97 lb in).
3. Install the electrical connector to the power window motor (2).
4. Install the front door water deflector. Install the front door trim panel.
REMOVAL PROCEDURE
1. Remove the front door trim panel.
2. Remove the front door water deflector.
3. Remove the electrical connector from the power window motor (2).
4. Remove the nuts (3) that retain the power window motor (2) to the front door module (1).
5. Remove the power window motor (2) from the vehicle.
INSTALLATION PROCEDURE
1. Install the power window motor (2) to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the nuts (3) in order to retain the power window motor (2) to the front door module (1).
Tighten
Tighten the retaining nuts to 11 N.m (97 lb in).
3. Install the electrical connector to the power window motor (2).
4. Install the front door water deflector. Install the front door trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.