Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2004EXPRESS 1500 RWD V8-5.3L VIN TREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSOIL PRESSURE SENSORSERVICE AND REPAIR
2004 Chevrolet Express 1500 RWD V8-5.3L VIN T
Oil Pressure Sensor: Service and Repair
2004 Chevrolet Express 1500 RWD V8-5.3L VIN TSECTION Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
Tools Required
^ J41712 Oil Pressure Sensor Socket
Removal Procedure
1. Remove the engine cover.
2. Disconnect the oil pressure sensor electrical connector (1).
3. Using J41712 or equivalent, remove the oil pressure sensor.
Installation Procedure
1. Apply sealant GM P/N 12346004, (Canadian P/N 10953480), or equivalent, to the threads of the oil pressure sensor.
Notice: Refer to Fastener Notice in Service Precautions.
2. Using J41712 or equivalent, install the oil pressure sensor.
Tighten the oil pressure sensor to 20 Nm (15 ft. lbs.).
3. Connect the oil pressure sensor electrical connector (1).
4. Install the engine cover.
Tools Required
^ J41712 Oil Pressure Sensor Socket
Removal Procedure
1. Remove the engine cover.
2. Disconnect the oil pressure sensor electrical connector (1).
3. Using J41712 or equivalent, remove the oil pressure sensor.
Installation Procedure
1. Apply sealant GM P/N 12346004, (Canadian P/N 10953480), or equivalent, to the threads of the oil pressure sensor.
Notice: Refer to Fastener Notice in Service Precautions.
2. Using J41712 or equivalent, install the oil pressure sensor.
Tighten the oil pressure sensor to 20 Nm (15 ft. lbs.).
3. Connect the oil pressure sensor electrical connector (1).
4. Install the engine cover.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.