Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2004EXPRESS 1500 RWD V6-4.3L VIN XREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - CRUISE CONTROLCRUISE CONTROL MODULESERVICE AND REPAIR
2004 Chevrolet Express 1500 RWD V6-4.3L VIN X
Cruise Control Module: Service and Repair
2004 Chevrolet Express 1500 RWD V6-4.3L VIN XSECTION Service and Repair
CRUISE CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Raise and support the hood.
2. Remove the air cleaner assembly from the vehicle.
3. Disconnect the electrical connector from the cruise control module.
4. Disconnect the cruise control cable from the cruise control module.
5. Remove the nuts (2) that retain the cruise control module to the cruise control bracket.
6. Remove the cruise control module (3) from the cruise control bracket (1).
7. Remove the cruise control module (3) from the vehicle.
INSTALLATION PROCEDURE
1. Install the cruise control module (3) to the vehicle.
2. Install the cruise control module (3) to the cruise control bracket (1).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the nuts (2) that retain the cruise control module (3) to the cruise control bracket (1).
Tighten
Tighten the nuts to 5 N.m (44 lb in).
4. Connect the cruise control cable to the cruise control module.
5. Connect the electrical connector to the cruise control module.
6. Install the air cleaner assembly to the vehicle.
7. Close the hood.
REMOVAL PROCEDURE
1. Raise and support the hood.
2. Remove the air cleaner assembly from the vehicle.
3. Disconnect the electrical connector from the cruise control module.
4. Disconnect the cruise control cable from the cruise control module.
5. Remove the nuts (2) that retain the cruise control module to the cruise control bracket.
6. Remove the cruise control module (3) from the cruise control bracket (1).
7. Remove the cruise control module (3) from the vehicle.
INSTALLATION PROCEDURE
1. Install the cruise control module (3) to the vehicle.
2. Install the cruise control module (3) to the cruise control bracket (1).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the nuts (2) that retain the cruise control module (3) to the cruise control bracket (1).
Tighten
Tighten the nuts to 5 N.m (44 lb in).
4. Connect the cruise control cable to the cruise control module.
5. Connect the electrical connector to the cruise control module.
6. Install the air cleaner assembly to the vehicle.
7. Close the hood.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.