Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2004AVALANCHE 1500 2WD V8-5.3L VIN TREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERSERVICE AND REPAIRTRANSMITTER SYNCHRONIZATION
2004 Chevrolet Avalanche 1500 2WD V8-5.3L VIN T
Transmitter Synchronization
2004 Chevrolet Avalanche 1500 2WD V8-5.3L VIN TSECTION Transmitter Synchronization
TRANSMITTER SYNCHRONIZATION
- Resynchronization may be necessary due to the security method used by the remote keyless entry system.The transmitter does not send the same signal twice to the passenger door module (PDM).
- The PDM will not respond to a signal that has been sent previously.This prevents anyone from recording and playing back the signal from the transmitter.
- The panic button should still operate normally when the system is out of synchronization.
- Resynchronization may be necessary under the following conditions:
- The battery in the transmitter is very weak.
- The battery in the transmitter was replaced.
- The battery in the vehicle has been in a low or no charge condition for an extended period of time.
- In order to resynchronize the transmitter with the PDM, perform the following steps:
1. Stand within 1.5 meters (5 ft) from the vehicle.
2. Simultaneously press and hold the LOCK and UNLOCK buttons on the transmitter for 7 seconds.The door locks should cycle in order to confirm resynchronization.
- Resynchronization may be necessary due to the security method used by the remote keyless entry system.The transmitter does not send the same signal twice to the passenger door module (PDM).
- The PDM will not respond to a signal that has been sent previously.This prevents anyone from recording and playing back the signal from the transmitter.
- The panic button should still operate normally when the system is out of synchronization.
- Resynchronization may be necessary under the following conditions:
- The battery in the transmitter is very weak.
- The battery in the transmitter was replaced.
- The battery in the vehicle has been in a low or no charge condition for an extended period of time.
- In order to resynchronize the transmitter with the PDM, perform the following steps:
1. Stand within 1.5 meters (5 ft) from the vehicle.
2. Simultaneously press and hold the LOCK and UNLOCK buttons on the transmitter for 7 seconds.The door locks should cycle in order to confirm resynchronization.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.