Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003C TAHOE 2WD V8-5.3L VIN TREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCOMPRESSOR HVACSERVICE AND REPAIRCOMPRESSOR MOUNTING BRACKET REPLACEMENT
2003 Chevrolet C Tahoe 2WD V8-5.3L VIN T
Compressor Mounting Bracket Replacement
2003 Chevrolet C Tahoe 2WD V8-5.3L VIN TSECTION Compressor Mounting Bracket Replacement
REMOVAL PROCEDURE
1. Remove the A/C compressor.
2. Remove the A/C belt tensioner bolts.
3. Remove the A/C belt tensioner.
4. Remove the A/C compressor bracket mounting bolts.
5. Remove the A/C compressor bracket.
INSTALLATION PROCEDURE
1. Install the A/C compressor bracket.
2. Install the A/C compressor bracket mounting bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the bolts to 50 N.m (37 lb ft).
3. Install the A/C belt tensioner.
4. Install the A/C belt tensioner bolts.
Tighten
Tighten the bolts to 50 N.m (37 lb ft).
5. Install the A/C compressor.
1. Remove the A/C compressor.
2. Remove the A/C belt tensioner bolts.
3. Remove the A/C belt tensioner.
4. Remove the A/C compressor bracket mounting bolts.
5. Remove the A/C compressor bracket.
INSTALLATION PROCEDURE
1. Install the A/C compressor bracket.
2. Install the A/C compressor bracket mounting bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the bolts to 50 N.m (37 lb ft).
3. Install the A/C belt tensioner.
4. Install the A/C belt tensioner bolts.
Tighten
Tighten the bolts to 50 N.m (37 lb ft).
5. Install the A/C compressor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.