Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003C TAHOE 2WD V8-5.3L VIN TREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCABIN TEMPERATURE SENSOR / SWITCHSERVICE AND REPAIRINSIDE AIR TEMPERATURE SENSOR ASSEMBLY REPLACEMENT
2003 Chevrolet C Tahoe 2WD V8-5.3L VIN T
Inside Air Temperature Sensor Assembly Replacement
2003 Chevrolet C Tahoe 2WD V8-5.3L VIN TSECTION Inside Air Temperature Sensor Assembly Replacement
REMOVAL PROCEDURE
1. Remove the left windshield garnish molding.
2. Remove the left center pillar assist handle.
3. Remove the left center pillar garnish molding.
4. Remove the left sunshade.
5. Gently pull down the headliner.
6. Disconnect the electrical connector from the inside air temperature sensor.
7. Partially remove the inside air temperature sensor from the headliner.
8. Remove the sensor grille from the inside air temperature sensor.
9. Remove the inside air temperature sensor from the headliner.
INSTALLATION PROCEDURE
1. Install the new sensor grille to the headliner.
2. Install the inside air temperature sensor to the headliner and sensor grille.
3. Connect the electrical connector to the inside air temperature sensor.
4. Install the left sunshade.
5. Install the left center pillar garnish molding.
6. Install the left center assist handle.
7. Install the left windshield garnish molding.
1. Remove the left windshield garnish molding.
2. Remove the left center pillar assist handle.
3. Remove the left center pillar garnish molding.
4. Remove the left sunshade.
5. Gently pull down the headliner.
6. Disconnect the electrical connector from the inside air temperature sensor.
7. Partially remove the inside air temperature sensor from the headliner.
8. Remove the sensor grille from the inside air temperature sensor.
9. Remove the inside air temperature sensor from the headliner.
INSTALLATION PROCEDURE
1. Install the new sensor grille to the headliner.
2. Install the inside air temperature sensor to the headliner and sensor grille.
3. Connect the electrical connector to the inside air temperature sensor.
4. Install the left sunshade.
5. Install the left center pillar garnish molding.
6. Install the left center assist handle.
7. Install the left windshield garnish molding.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.