Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003C TAHOE 2WD V8-5.3L VIN TREPAIR AND DIAGNOSISBODY AND FRAMETAILGATESERVICE AND REPAIREND GATE REPLACEMENT
2003 Chevrolet C Tahoe 2WD V8-5.3L VIN T
End Gate Replacement
2003 Chevrolet C Tahoe 2WD V8-5.3L VIN TSECTION End Gate Replacement
End Gate Replacement
Removal Procedure
1. Lower the endgate.
2. Remove the theft deterrent bolt.
3. With an assistant, raise the endgate to a 45 degree angle.
4. Remove the cable on each side from the side panel striker bolts.
5. Remove the endgate from the right side hinge assembly by lifting up on the right side.
6. With an assistant, remove the endgate from the left body side hinge by sliding to the right and lifting.
Installation Procedure
1. With an assistant, install the endgate onto the left body side hinge by sliding to the left and lifting.
2. Install the endgate to the right side hinge assembly by holding the endgate at a 45 degree angle and lowering the endgate onto the hinge.
3. Install the cables onto the side panel striker bolts.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the theft deterrent bolt.
Tighten the bolt to 25 N.m (18 lb ft).
5. Inspect the endgate operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.