Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003AVALANCHE 1500 2WD V8-5.3L VIN TREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCOMPRESSOR HVACSERVICE AND REPAIRCOMPRESSOR OIL BALANCING
2003 Chevrolet Avalanche 1500 2WD V8-5.3L VIN T
Compressor Oil Balancing
2003 Chevrolet Avalanche 1500 2WD V8-5.3L VIN TSECTION Compressor Oil Balancing
DRAINING
1. Drain the oil from both the suction and discharge ports of the removed compressor into a clean, graduated container.
Rotate the compressor shaft to assist in draining the compressor.
IMPORTANT: Drain and measure as much of the refrigerant oil as possible from the removed compressor.
2. Measure and record the amount of oil drained from the removed compressor.
This measurement will be used during installation of the replacement compressor.
3. Properly discard the used refrigerant oil.
BALANCING
1. The replacement compressor is shipped with the total system capacity of refrigerant oil.
IMPORTANT: The refrigerant oil in the A/C system must be balanced during compressor replacement.
2. Before installing the compressor, the refrigerant oil will have to be partially drained:
2.1. Refer to the amount of refrigerant oil recorded during the compressor removal.
2.2. Subtract the amount recorded from the total system capacity.
The difference between the total system capacity and the recorded amount is the calculated amount to be drained from the replacement compressor.
3. Drain the calculated amount of refrigerant oil from the replacement compressor.
1. Drain the oil from both the suction and discharge ports of the removed compressor into a clean, graduated container.
Rotate the compressor shaft to assist in draining the compressor.
IMPORTANT: Drain and measure as much of the refrigerant oil as possible from the removed compressor.
2. Measure and record the amount of oil drained from the removed compressor.
This measurement will be used during installation of the replacement compressor.
3. Properly discard the used refrigerant oil.
BALANCING
1. The replacement compressor is shipped with the total system capacity of refrigerant oil.
IMPORTANT: The refrigerant oil in the A/C system must be balanced during compressor replacement.
2. Before installing the compressor, the refrigerant oil will have to be partially drained:
2.1. Refer to the amount of refrigerant oil recorded during the compressor removal.
2.2. Subtract the amount recorded from the total system capacity.
The difference between the total system capacity and the recorded amount is the calculated amount to be drained from the replacement compressor.
3. Drain the calculated amount of refrigerant oil from the replacement compressor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.