SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002MONTE CARLO V6-3.8L VIN KREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSDATA LINK CONNECTORSERVICE AND REPAIR
2002 Chevrolet Monte Carlo V6-3.8L VIN K

Data Link Connector: Service and Repair

2002 Chevrolet Monte Carlo V6-3.8L VIN KSECTION Service and Repair
REMOVAL PROCEDURE




1. Remove the screws from the data link connector
2. Reposition the data link connector from the instrument panel.

INSTALLATION PROCEDURE




1. Position the data link connector to the instrument panel.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the screws to the data link connector.

Tighten
Tighten the data link connector screws to 2 N.m (18 lb in).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.