Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002EXPRESS 1/2 TON VAN V8-5.7L VIN RREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - INSTRUMENT PANELAUDIBLE WARNING DEVICE CONTROL MODULESERVICE AND REPAIR
2002 Chevrolet Express 1/2 Ton Van V8-5.7L VIN R
Audible Warning Device Control Module: Service and Repair
2002 Chevrolet Express 1/2 Ton Van V8-5.7L VIN RSECTION Service and Repair
MULTIFUNCTION ALARM MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the instrument panel driver knee bolster panel.
2. Disconnect the multi-function audio alarm module (2) from the retainer on the left inside knee bolster bracket (4).
3. Disconnect the electrical connector (3) from the multi-function audio alarm module (2).
4. Remove the multi-function audio alarm module (2) from the vehicle.
INSTALLATION PROCEDURE
1. Install the multi-function audio alarm module (2) to the vehicle.
2. Connect the electrical connector (3) to the multi-function audio alarm module (2).
3. Connect the multi-function audio alarm module (2) to the retainer (4) on the left inside knee bolster bracket.
4. Install the instrument panel driver knee bolster panel.
REMOVAL PROCEDURE
1. Remove the instrument panel driver knee bolster panel.
2. Disconnect the multi-function audio alarm module (2) from the retainer on the left inside knee bolster bracket (4).
3. Disconnect the electrical connector (3) from the multi-function audio alarm module (2).
4. Remove the multi-function audio alarm module (2) from the vehicle.
INSTALLATION PROCEDURE
1. Install the multi-function audio alarm module (2) to the vehicle.
2. Connect the electrical connector (3) to the multi-function audio alarm module (2).
3. Connect the multi-function audio alarm module (2) to the retainer (4) on the left inside knee bolster bracket.
4. Install the instrument panel driver knee bolster panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.