Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002EXPRESS 1 TON VAN V8-8.1L VIN GREPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGSTEERING COLUMNSERVICE AND REPAIRWITH STANDARD COLUMNELECTRONIC COLUMN LOCK MODULE - ASSEMBLE
2002 Chevrolet Express 1 Ton Van V8-8.1L VIN G
Electronic Column Lock Module - Assemble
2002 Chevrolet Express 1 Ton Van V8-8.1L VIN GSECTION Electronic Column Lock Module - Assemble
Electronic Column Lock Module -Assemble - Off Vehicle (Standard Column)
Tools Required
^ J41396 Park Lock Cable Pliers
1. Install the electronic lock module assembly (1) onto the steering column housing assembly.
Notice: Refer to Fastener Notice in Service Precautions.
2. Screw the 3 pan head tapping screws (2) into the electronic lock module assembly.
Tighten the pan head tapping screws to 7 Nm (62 inch lbs.).
Caution: Refer to SIR Inflator Module Coil Caution in Service Precautions.
3. Connect the park lock cable assembly (1).
^ Place the lock cylinder in the OFF-LOCK position.
^ Place the gear shift lever clevis into the PARK position.
^ Press the locking tab on the end of the park lock cable assembly (1) into the slot in the electronic lock module assembly.
4. Install the ignition and key alarm switch assembly.
5. Install the upper steering column housing components.
6. Install the ignition lock cylinder.
7. Enable the inflatable restraint steering wheel module.
Tools Required
^ J41396 Park Lock Cable Pliers
1. Install the electronic lock module assembly (1) onto the steering column housing assembly.
Notice: Refer to Fastener Notice in Service Precautions.
2. Screw the 3 pan head tapping screws (2) into the electronic lock module assembly.
Tighten the pan head tapping screws to 7 Nm (62 inch lbs.).
Caution: Refer to SIR Inflator Module Coil Caution in Service Precautions.
3. Connect the park lock cable assembly (1).
^ Place the lock cylinder in the OFF-LOCK position.
^ Place the gear shift lever clevis into the PARK position.
^ Press the locking tab on the end of the park lock cable assembly (1) into the slot in the electronic lock module assembly.
4. Install the ignition and key alarm switch assembly.
5. Install the upper steering column housing components.
6. Install the ignition lock cylinder.
7. Enable the inflatable restraint steering wheel module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.