Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002EXPRESS 1 TON VAN V8-8.1L VIN GREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCOOLANT TEMPERATURE SENSOR/SWITCH (FOR COMPUTER)SERVICE AND REPAIR
2002 Chevrolet Express 1 Ton Van V8-8.1L VIN G
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
2002 Chevrolet Express 1 Ton Van V8-8.1L VIN GSECTION Service and Repair
REMOVAL PROCEDURE
1. Turn OFF the ignition.
2. Remove the engine cover.
3. Drain the cooling system below the level of the ECT sensor. Refer to Draining and Filling Cooling System in Cooling System.
4. Disconnect the ECT electrical connector (2).
5. Remove the ECT electrical connector from the bracket (1).
6. Remove the ECT sensor (3).
INSTALLATION PROCEDURE
1. Coat the threads with sealer P/N 9985253 or equivalent.
NOTE: Refer to Component Fastener Tightening Notice in Service Precautions.
2. Carefully install the ECT sensor (3).
Tighten
Tighten the ECT sensor to 20 N.m (15 lb ft).
3. Connect the ECT harness connector (2) to the ECT sensor (3).
4. Refill the cooling system. Refer to Draining and Filling Cooling System in Cooling System.
5. Install the engine cover.
6. Connect the ECT electrical connector to the bracket (1).
1. Turn OFF the ignition.
2. Remove the engine cover.
3. Drain the cooling system below the level of the ECT sensor. Refer to Draining and Filling Cooling System in Cooling System.
4. Disconnect the ECT electrical connector (2).
5. Remove the ECT electrical connector from the bracket (1).
6. Remove the ECT sensor (3).
INSTALLATION PROCEDURE
1. Coat the threads with sealer P/N 9985253 or equivalent.
NOTE: Refer to Component Fastener Tightening Notice in Service Precautions.
2. Carefully install the ECT sensor (3).
Tighten
Tighten the ECT sensor to 20 N.m (15 lb ft).
3. Connect the ECT harness connector (2) to the ECT sensor (3).
4. Refill the cooling system. Refer to Draining and Filling Cooling System in Cooling System.
5. Install the engine cover.
6. Connect the ECT electrical connector to the bracket (1).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.