Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002EXPRESS 1 TON VAN V8-8.1L VIN GREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERSERVICE AND REPAIRTRANSMITTER PROGRAMMING
2002 Chevrolet Express 1 Ton Van V8-8.1L VIN G
Transmitter Programming
2002 Chevrolet Express 1 Ton Van V8-8.1L VIN GSECTION Transmitter Programming
IMPORTANT: All transmitters which are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Up to 4 transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle.
The RCDLR may be personalized in order to chirp the horns when the vehicle is locked using a transmitter. In order to enable the horn chip, turn the ignition OFF prior to performing the transmitter programming. In order to disable the horn chirp, turn the ignition ON prior to performing the transmitter programming. Perform the following in order to program the transmitter(s):
1. Connect a jumper wire between the keyless entry program enable circuit of the data link connector (DLC) and a good ground. The doors will lock and unlock in order to confirm that the remote control door lock receiver has entered the transmitter programming mode.
2. Press and hold the LOCK button and the UNLOCK button simultaneously on 1 transmitter. After a delay of approximately 10 seconds, the doors will lock and unlock in order to confirm the programming of that transmitter.
3. Repeat the previous step to program up to 4 transmitters.
4. Remove the jumper wire from the DLC.
5. Operate the transmitter functions in order to verify correct system operation.
The RCDLR may be personalized in order to chirp the horns when the vehicle is locked using a transmitter. In order to enable the horn chip, turn the ignition OFF prior to performing the transmitter programming. In order to disable the horn chirp, turn the ignition ON prior to performing the transmitter programming. Perform the following in order to program the transmitter(s):
1. Connect a jumper wire between the keyless entry program enable circuit of the data link connector (DLC) and a good ground. The doors will lock and unlock in order to confirm that the remote control door lock receiver has entered the transmitter programming mode.
2. Press and hold the LOCK button and the UNLOCK button simultaneously on 1 transmitter. After a delay of approximately 10 seconds, the doors will lock and unlock in order to confirm the programming of that transmitter.
3. Repeat the previous step to program up to 4 transmitters.
4. Remove the jumper wire from the DLC.
5. Operate the transmitter functions in order to verify correct system operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.