Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001MONTE CARLO V6-3.8L VIN KREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - INSTRUMENT PANELAUDIBLE WARNING DEVICE CONTROL MODULESERVICE AND REPAIR
2001 Chevrolet Monte Carlo V6-3.8L VIN K
Audible Warning Device Control Module: Service and Repair
2001 Chevrolet Monte Carlo V6-3.8L VIN KSECTION Service and Repair
MULTIFUNCTION ALARM MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the instrument cluster trim panel..
2. Remove the screws from the radio delete plate.
3. Remove the radio delete plate from the instrument panel.
4. Disconnect the electrical connector from the multifunction alarm module.
5. Remove the multifunction alarm module from the instrument panel by lifting up and out.
INSTALLATION PROCEDURE
1. Install the multifunction alarm module to the instrument panel by pressing in place until fully seated.
2. Connect the electrical connector to the multifunction alarm module.
3. Install the radio delete plate to the instrument panel.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the screws to the radio delete plate.
Tighten
Tighten the screws to 2 N.m (18 lb in).
5. Install the instrument cluster trim panel.
REMOVAL PROCEDURE
1. Remove the instrument cluster trim panel..
2. Remove the screws from the radio delete plate.
3. Remove the radio delete plate from the instrument panel.
4. Disconnect the electrical connector from the multifunction alarm module.
5. Remove the multifunction alarm module from the instrument panel by lifting up and out.
INSTALLATION PROCEDURE
1. Install the multifunction alarm module to the instrument panel by pressing in place until fully seated.
2. Connect the electrical connector to the multifunction alarm module.
3. Install the radio delete plate to the instrument panel.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the screws to the radio delete plate.
Tighten
Tighten the screws to 2 N.m (18 lb in).
5. Install the instrument cluster trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.