Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001MONTE CARLO V6-3.8L VIN KREPAIR AND DIAGNOSISCRUISE CONTROLBRAKE SWITCH (CRUISE CONTROL)ADJUSTMENTS
2001 Chevrolet Monte Carlo V6-3.8L VIN K
Brake Switch (Cruise Control): Adjustments
2001 Chevrolet Monte Carlo V6-3.8L VIN KSECTION Adjustments
IMPORTANT: The cruise control release switch and the stop lamp switch are adjusted together. Incorrect adjustment of either of these switches may cause premature brake lining wear or the cruise control system to not work properly.
1. Remove the left side insulator panel.
2. Press the brake pedal fully.
3. Push the switches into the retainers until the switches are fully seated.
4. Pull the brake pedal rearward against the pedal stop until the audible clicks can no longer be heard.
5. The following brake pedal travel distances can be used to validate the proper cruise control release switch and stop lamp switch adjustment.
Cruise control release switch and the stop lamp switch contacts must actuate at 3.5 to 12.5 mm (1/8 to 1/2 in) of the brake pedal travel measured at the centerline of the brake pedal pad. Nominal actuation of the stop lamp switch contacts is about 4.5 mm (3/16 in) after the cruse control release switch actuation.
6. Install the left side insulator panel.
1. Remove the left side insulator panel.
2. Press the brake pedal fully.
3. Push the switches into the retainers until the switches are fully seated.
4. Pull the brake pedal rearward against the pedal stop until the audible clicks can no longer be heard.
5. The following brake pedal travel distances can be used to validate the proper cruise control release switch and stop lamp switch adjustment.
Cruise control release switch and the stop lamp switch contacts must actuate at 3.5 to 12.5 mm (1/8 to 1/2 in) of the brake pedal travel measured at the centerline of the brake pedal pad. Nominal actuation of the stop lamp switch contacts is about 4.5 mm (3/16 in) after the cruse control release switch actuation.
6. Install the left side insulator panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.