Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001MONTE CARLO V6-3.8L VIN KREPAIR AND DIAGNOSISBODY AND FRAMESEATSSEAT TEMPERATURE CONTROL MODULESERVICE AND REPAIR
2001 Chevrolet Monte Carlo V6-3.8L VIN K
Seat Temperature Control Module: Service and Repair
2001 Chevrolet Monte Carlo V6-3.8L VIN KSECTION Service and Repair
Front Seat Heater Control Module Replacement
Removal Procedure
1. Remove the front seat adjuster to floor pan bolts.
2. Tilt the seat forward.
3. Disconnect the electric connectors from the heated seat module.
4. Cut the tie straps to the module.
5. Remove the heated seat module.
Installation Procedure
1. Position the heated seat module under the seat.
2. Connect the electric connectors to the heated seat module.
3. Install new tie straps to the module.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the front bucket seat adjuster-to-floor pan bolts.
Tighten the front bucket seat adjuster-to-floor pan bolts to 42 N.m (31 lb ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.