Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001MONTE CARLO V6-3.4L VIN EREPAIR AND DIAGNOSISSPECIFICATIONSFLUID TYPE SPECIFICATIONSCOOLANT
2001 Chevrolet Monte Carlo V6-3.4L VIN E
Coolant
2001 Chevrolet Monte Carlo V6-3.4L VIN ESECTION Coolant
Coolant: 50/50 mixture of clean, drinkable water and use only GM Goodwrench DEX-COOL or Havoline DEX-COOL coolant.
Notice Mixing conventional green (silicated) coolant with DEX-COOL may cause premature engine, heater core or radiator corrosion. It will also degrade the service interval from 5yrs./150,000 miles to 2yrs./30,000 miles (50,000 km) if left in the contaminated condition. If contamination occurs, the cooling system must be flushed twice immediately and re-filled with a 50/50 mixture of DEX-COOL and clean water in order to preserve the enhanced properties and extended service interval of DEX-COOL.
Engine Coolant Supplemental Sealers
Notice DO NOT use cooling system seal tabs, or similar compounds, unless otherwise instructed. The use of cooling system seal tabs, or similar compounds, may restrict coolant flow through the passages of the cooling system or the engine components. Restricted coolant flow may cause engine overheating and/or damage to the cooling system or the engine components/assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.