Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001METRO L4-079 1.3L VIN 2 MFIREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BRAKES AND TRACTION CONTROLELECTRONIC BRAKE CONTROL MODULESERVICE AND REPAIRELECTRONIC BRAKE CONTROL RELAY
2001 Chevrolet Metro L4-079 1.3L VIN 2 MFI
Electronic Brake Control Relay
2001 Chevrolet Metro L4-079 1.3L VIN 2 MFISECTION Electronic Brake Control Relay
Removal Procedure
1. Open the hood.
2. Remove the underhood Electrical Center cover.
3. Remove the Electronic Brake Control Relay (2) from the underhood electrical center (1).
Installation Procedure
1. Install the Electronic Brake Control Relay (2) into the underhood electrical center (1).
2. Install the underhood Electrical Center cover.
3. Close the hood.
4. Perform A Diagnostic System Check - ABS. Diagnostic System Check
1. Open the hood.
2. Remove the underhood Electrical Center cover.
3. Remove the Electronic Brake Control Relay (2) from the underhood electrical center (1).
Installation Procedure
1. Install the Electronic Brake Control Relay (2) into the underhood electrical center (1).
2. Install the underhood Electrical Center cover.
3. Close the hood.
4. Perform A Diagnostic System Check - ABS. Diagnostic System Check
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.