Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001METRO L4-079 1.3L VIN 2 MFIREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSVEHICLE SPEED SENSORSERVICE AND REPAIR
2001 Chevrolet Metro L4-079 1.3L VIN 2 MFI
Vehicle Speed Sensor: Service and Repair
2001 Chevrolet Metro L4-079 1.3L VIN 2 MFISECTION Service and Repair
REMOVAL PROCEDURE
1. Disconnect the electrical connector (1) from the Vehicle Speed Sensor (VSS).
2. Remove the bolt (2) and the VSS (3) from the top of the transaxle.
INSTALLATION PROCEDURE
1. Install the VSS (3) to the transaxle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Secure the VSS with the bolt (2).
Tighten
Tighten the bolt to 8 N.m (72 lb in).
3. Connect the VSS electrical connector (1).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.