Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001LUMINA V6-3.1L VIN JREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - CRUISE CONTROLCRUISE CONTROL MODULESERVICE AND REPAIR
2001 Chevrolet Lumina V6-3.1L VIN J
Cruise Control Module: Service and Repair
2001 Chevrolet Lumina V6-3.1L VIN JSECTION Service and Repair
REMOVAL PROCEDURE
The cruise control module is mounted to the left strut tower and must be serviced as a complete unit.
1. Remove the cruise control cable from the cruise control module.
2. Remove the electrical connector from the cruise control module.
3. Remove the cruise control module mounting nuts.
4. Remove the cruise control module from the vehicle.
INSTALLATION PROCEDURE
1. Install the cruise control module on the mounting studs located on the shock tower.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the cruise control module mounting nuts.
Tighten
Tighten the cruise control module mounting nuts to 2 N.m (18 lb in).
3. Install the electrical connector to the cruise control module.
4. Install the cruise control cable to the cruise control module.
5. Adjust the cruise control cable. Refer to Cruise Control Cable Adjustment.
The cruise control module is mounted to the left strut tower and must be serviced as a complete unit.
1. Remove the cruise control cable from the cruise control module.
2. Remove the electrical connector from the cruise control module.
3. Remove the cruise control module mounting nuts.
4. Remove the cruise control module from the vehicle.
INSTALLATION PROCEDURE
1. Install the cruise control module on the mounting studs located on the shock tower.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the cruise control module mounting nuts.
Tighten
Tighten the cruise control module mounting nuts to 2 N.m (18 lb in).
3. Install the electrical connector to the cruise control module.
4. Install the cruise control cable to the cruise control module.
5. Adjust the cruise control cable. Refer to Cruise Control Cable Adjustment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.