Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001LUMINA V6-3.1L VIN JREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BRAKES AND TRACTION CONTROLELECTRONIC BRAKE CONTROL MODULESERVICE AND REPAIRELECTRONIC BRAKE CONTROL MODULE (EBCM)
2001 Chevrolet Lumina V6-3.1L VIN J
Electronic Brake Control Module (EBCM)
2001 Chevrolet Lumina V6-3.1L VIN JSECTION Electronic Brake Control Module (EBCM)
Removal Procedure
1. Remove the IP sound insulator panel. Refer to Trim Pad Replacement - IP in Instrument Panel, Gauges and Warning Indicators.
2. Use pressure tabs in order to release the EBCM (1) from the EBCM bracket (2).
3. Remove the EBCM electrical connectors.
Installation Procedure
1. Install the EBCM electrical connectors.
2. Slide the EBCM (1) into the EBCM bracket (2) until pressure tabs secure the EBCM.
3. Install the IP sound insulator panel. Refer to Trim Pad Replacement - IP in Instrument Panel, Gauges and Warning Indicators.
1. Remove the IP sound insulator panel. Refer to Trim Pad Replacement - IP in Instrument Panel, Gauges and Warning Indicators.
2. Use pressure tabs in order to release the EBCM (1) from the EBCM bracket (2).
3. Remove the EBCM electrical connectors.
Installation Procedure
1. Install the EBCM electrical connectors.
2. Slide the EBCM (1) into the EBCM bracket (2) until pressure tabs secure the EBCM.
3. Install the IP sound insulator panel. Refer to Trim Pad Replacement - IP in Instrument Panel, Gauges and Warning Indicators.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.