Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001LUMINA V6-3.1L VIN JREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - IGNITION SYSTEMIGNITION CONTROL MODULESERVICE AND REPAIR
2001 Chevrolet Lumina V6-3.1L VIN J
Ignition Control Module: Service and Repair
2001 Chevrolet Lumina V6-3.1L VIN JSECTION Service and Repair
REMOVAL PROCEDURE
1. Disconnect all the electrical connectors at the ignition control module.
2. Note position of spark plug wires for installation and disconnect the spark plug wires from ignition coils.
3. Remove the screws securing coil assemblies to ignition control module.
4. Disconnect the coils from ignition control module.
5. Remove the fasteners securing ignition control module assembly to engine.
6. Remove the ignition control module from the bracket.
INSTALLATION PROCEDURE
1. Install the ignition control module on the bracket.
2. Install the coils to ignition control module.
3. Reinstall the fasteners securing ignition control module assembly to engine.
NOTE: Refer to Fastener Notice in Cautions and Notices.
4. Reinstall the screws.
Tighten
Tighten the screws to 4-5 Nm (40 lb in).
5. Connect the spark plug wires as noted during removal.
6. Connect the electrical connectors to the ignition control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.