Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001LUMINA V6-3.1L VIN JREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSOIL PRESSURE SENSORSERVICE AND REPAIR
2001 Chevrolet Lumina V6-3.1L VIN J
Oil Pressure Sensor: Service and Repair
2001 Chevrolet Lumina V6-3.1L VIN JSECTION Service and Repair
Removal Procedure
1. Disconnect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure.
2. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
3. Disconnect the electrical connector from the engine oil pressure sensor.
4. Remove the engine oil pressure switch.
Installation Procedure
1. Refer to Fastener Notice in Service Precautions. Install the engine oil pressure switch.
Tighten the switch to 13 Nm (115 inch lbs.).
2. Connect the electrical connector to the engine oil pressure switch.
3. Lower the vehicle.
4. Connect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure.
1. Disconnect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure.
2. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
3. Disconnect the electrical connector from the engine oil pressure sensor.
4. Remove the engine oil pressure switch.
Installation Procedure
1. Refer to Fastener Notice in Service Precautions. Install the engine oil pressure switch.
Tighten the switch to 13 Nm (115 inch lbs.).
2. Connect the electrical connector to the engine oil pressure switch.
3. Lower the vehicle.
4. Connect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.