Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001LUMINA V6-3.1L VIN JREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCOMPRESSOR HVACTESTING AND INSPECTION
2001 Chevrolet Lumina V6-3.1L VIN J
Compressor HVAC: Testing and Inspection
2001 Chevrolet Lumina V6-3.1L VIN JSECTION Testing and Inspection
Compressor Leak Testing (V5 Direct Mount)
TOOLS REQUIRED
^ J 39400-A Leak Detector
^ J 39500-B R-134a Air Conditioning Refrigerant Recovery, Recycling And Recharging System
^ J 39893 Pressure Testing Connector
1. With the sealing washers in place, install the J 39893 on the rear head of the compressor.
2. Connect the gage charging lines and the J 39500-B.
3. Pressurize the suction and the high-side of the compressor with R-134a refrigerant.
4. With the compressor in a horizontal position, rotate by hand the compressor shaft in the operating direction.
5. Rotate the shaft several times.
6. Using the J 39400-A, check for leaks at the following locations:
^ Pressure relief valve
^ Rear head switch
^ Front head seals
^ Rear head seals
^ Through bolt head gaskets
^ Compressor shaft seal
7. Perform the measures necessary to correct any external leaks found.
8. Recheck for leaks following any repair.
9. Recover the refrigerant.
10. Disconnect the hoses from the J 39893.
11. Remove the J 39893.
TOOLS REQUIRED
^ J 39400-A Leak Detector
^ J 39500-B R-134a Air Conditioning Refrigerant Recovery, Recycling And Recharging System
^ J 39893 Pressure Testing Connector
1. With the sealing washers in place, install the J 39893 on the rear head of the compressor.
2. Connect the gage charging lines and the J 39500-B.
3. Pressurize the suction and the high-side of the compressor with R-134a refrigerant.
4. With the compressor in a horizontal position, rotate by hand the compressor shaft in the operating direction.
5. Rotate the shaft several times.
6. Using the J 39400-A, check for leaks at the following locations:
^ Pressure relief valve
^ Rear head switch
^ Front head seals
^ Rear head seals
^ Through bolt head gaskets
^ Compressor shaft seal
7. Perform the measures necessary to correct any external leaks found.
8. Recheck for leaks following any repair.
9. Recover the refrigerant.
10. Disconnect the hoses from the J 39893.
11. Remove the J 39893.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.