Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001LUMINA V6-3.1L VIN JREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SWITCHSERVICE AND REPAIR
2001 Chevrolet Lumina V6-3.1L VIN J
Cruise Control Switch: Service and Repair
2001 Chevrolet Lumina V6-3.1L VIN JSECTION Service and Repair
REMOVAL PROCEDURE
1. Remove the left side instrument panel insulator.
2. Disconnect the electrical connector from the cruise release switch.
3. Remove the cruise release switch from the retainer on the brake pedal bracket.
INSTALLATION PROCEDURE
1. Install the cruise release switch to the retainer on the brake pedal bracket.
2. Connect the electrical connector onto the cruise release switch.
3. Adjust the cruise release switch. Refer to Cruise Release Switch Adjustment.
4. Install the left side instrument panel insulator.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.