Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001LUMINA V6-3.1L VIN JREPAIR AND DIAGNOSISBODY AND FRAMESPLASH GUARDSERVICE AND REPAIR
2001 Chevrolet Lumina V6-3.1L VIN J
Splash Guard: Service and Repair
2001 Chevrolet Lumina V6-3.1L VIN JSECTION Service and Repair
Engine Splash Shield Replacement
Removal Procedure
Tool Required
J 38778 Trim Remover
1. Remove the push-in retainers from the engine splash to the lower flange of the engine compartment side rail using J 38778 .
2. Remove the engine splash shield from the lower flange of the engine compartment side rail.
Installation Procedure
1. Position the engine splash shield to the lower flange of the engine compartment side rail.
2. Align the holes in the engine splash shield to the holes in the outboard side engine compartment side rail.
3. Install the push-in retainers to the engine splash shield.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.