Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001ASTRO VAN L AWD V6-4.3L VIN WREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY RECEIVERSERVICE AND REPAIR
2001 Chevrolet Astro Van L AWD V6-4.3L VIN W
Keyless Entry Receiver: Service and Repair
2001 Chevrolet Astro Van L AWD V6-4.3L VIN WSECTION Service and Repair
REMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the left knee bolster.
2. Disconnect the remote keyless entry antenna (2) from the receiver (5).
3. Disconnect the remote keyless entry electrical connector (4) from the receiver (5).
4. Remove the remote keyless entry module screws from the bracket (3).
5. Remove the remote keyless entry module from the carrier.
INSTALLATION PROCEDURE
1. Install the remote keyless entry module to the carrier.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the remote keyless entry module screws to the bracket (3).
Tighten
Tighten the remote keyless entry module screws to the bracket (3) to 2 N.m (18 lb in).
3. Connect the remote keyless entry antenna (2) to the receiver (5).
4. Connect the remote keyless entry electrical connector (4) to the receiver (5).
5. Install the left knee bolster.
6. Reprogram the transmitter. Refer to Transmitter Programming. Transmitter Programming
7. Verify that the system operates properly.
REMOVAL PROCEDURE
1. Remove the left knee bolster.
2. Disconnect the remote keyless entry antenna (2) from the receiver (5).
3. Disconnect the remote keyless entry electrical connector (4) from the receiver (5).
4. Remove the remote keyless entry module screws from the bracket (3).
5. Remove the remote keyless entry module from the carrier.
INSTALLATION PROCEDURE
1. Install the remote keyless entry module to the carrier.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the remote keyless entry module screws to the bracket (3).
Tighten
Tighten the remote keyless entry module screws to the bracket (3) to 2 N.m (18 lb in).
3. Connect the remote keyless entry antenna (2) to the receiver (5).
4. Connect the remote keyless entry electrical connector (4) to the receiver (5).
5. Install the left knee bolster.
6. Reprogram the transmitter. Refer to Transmitter Programming. Transmitter Programming
7. Verify that the system operates properly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.