Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000S10/T10 P/U 2WD V6-4.3L VIN WREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW FRAMESERVICE AND REPAIR
2000 Chevrolet S10/T10 P/U 2WD V6-4.3L VIN W
Window Frame: Service and Repair
2000 Chevrolet S10/T10 P/U 2WD V6-4.3L VIN WSECTION Service and Repair
REMOVAL PROCEDURE
1. Remove the door trim panel.
2. Remove the water deflector.
3. Remove the bolts that retain the front run channel to the door.
4. Carefully pull the front run channel in order to disengage the run channel from the window weatherstrip.
5. Remove the front run channel from the door.
6. Slide the window forward.
7. Remove the bolts that retain the rear run channel to the door.
8. Carefully pull the front run channel in order to disengage the run channel from the window weatherstrip.
9. Remove the rear run channel from the door.
INSTALLATION PROCEDURE
1. Install the rear run channel to the door.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the bolts that retain the rear run channel to the door.
Tighten
Tighten the bolts to 10 N.m (88 lb in).
3. Slide the window rearward into the rear run channel.
4. Install the front run channel to the door.
5. Install the bolts that retain the front run channel to the door.
Tighten
Tighten the bolts to 10 N.m (88 lb in).
6. Install the water deflector.
7. Install the door trim panel.
1. Remove the door trim panel.
2. Remove the water deflector.
3. Remove the bolts that retain the front run channel to the door.
4. Carefully pull the front run channel in order to disengage the run channel from the window weatherstrip.
5. Remove the front run channel from the door.
6. Slide the window forward.
7. Remove the bolts that retain the rear run channel to the door.
8. Carefully pull the front run channel in order to disengage the run channel from the window weatherstrip.
9. Remove the rear run channel from the door.
INSTALLATION PROCEDURE
1. Install the rear run channel to the door.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the bolts that retain the rear run channel to the door.
Tighten
Tighten the bolts to 10 N.m (88 lb in).
3. Slide the window rearward into the rear run channel.
4. Install the front run channel to the door.
5. Install the bolts that retain the front run channel to the door.
Tighten
Tighten the bolts to 10 N.m (88 lb in).
6. Install the water deflector.
7. Install the door trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.