Right Front Window Switch Operation

2000 Chevrolet S10/T10 P/U 2WD V6-4.3L VIN WSECTION Right Front Window Switch Operation
Place the ignition switch in the RUN position in order to supply voltage to the right door lock and side window switch through the POWER WINDOW circuit breaker and CKT 1001 (DK GRN) to terminal F. Press the UP switch in the right front window switch in order to supply battery voltage to the right front side window regulator motor through CKT 666 (DK BLU). The motor is grounded through the following circuits:
^ CKT 667 (BRN) - The down contact in the window switch
^ CKT 167 (TAN) - The down contact in the left front door lock and side window switch

The motor runs in order to drive the window UP. Press the DOWN window switch in order to supply battery voltage to the window regulator motor in the opposite direction through CKT 667 (BRN).

The motor is grounded through the following circuits:
^ CKT 666 (DK BLU) - The up contact in the window switch
^ CKT 166 (LT BLU) - The up contact in the left front door lock and side window switch

The motor runs in order to drive the window DOWN.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.