Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000S10/T10 P/U 2WD V6-4.3L VIN WREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULEDESCRIPTION AND OPERATIONCIRCUIT DESCRIPTIONFRONT FOG LAMPS
2000 Chevrolet S10/T10 P/U 2WD V6-4.3L VIN W
Front Fog Lamps
2000 Chevrolet S10/T10 P/U 2WD V6-4.3L VIN WSECTION Front Fog Lamps
The front fog lamps are a controlled by the BCM. If the park lamps are ON, the high beams are OFF and the fog lamp switch is pressed, the BCM will command the fog lamp relay ON. When the BCM senses a momentary low signal on the fog lamp switch circuit, the fog lamps will turn OFF. Toggle the HIGH/LOW beam switch and the front fog lamps will toggle ON/OFF.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.