Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000S10/T10 P/U 2WD V6-4.3L VIN WREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRHVAC SYSTEM - AUTOMATICCONTROL ASSEMBLY REPLACEMENT
2000 Chevrolet S10/T10 P/U 2WD V6-4.3L VIN W
Control Assembly Replacement
2000 Chevrolet S10/T10 P/U 2WD V6-4.3L VIN WSECTION Control Assembly Replacement
REMOVAL PROCEDURE
1. Remove the instrument panel accessory trim plate, refer to Service and Repair
2. Remove the HVAC control assembly retaining screws.
3. Depress the HVAC control assembly retaining tabs and remove the HVAC control assembly from the instrument panel.
4. Disconnect the electrical connectors from the HVAC control assembly.
5. Remove the HVAC control assembly bulb from the HVAC control assembly and retain.
INSTALLATION PROCEDURE
1. Install the HVAC control assembly bulb to the HVAC control assembly.
2. Connect the electrical connectors to the HVAC control assembly.
3. Install the HVAC control assembly into the instrument panel, ensuring that the HVAC control assembly retaining tabs lock into place.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the HVAC control assembly retaining screws.
Tighten
Tighten the control assembly screws to 1.9 N.m (17 lb in).
5. Install the instrument panel accessory trim plate, refer to see Service and Repair
1. Remove the instrument panel accessory trim plate, refer to Service and Repair
2. Remove the HVAC control assembly retaining screws.
3. Depress the HVAC control assembly retaining tabs and remove the HVAC control assembly from the instrument panel.
4. Disconnect the electrical connectors from the HVAC control assembly.
5. Remove the HVAC control assembly bulb from the HVAC control assembly and retain.
INSTALLATION PROCEDURE
1. Install the HVAC control assembly bulb to the HVAC control assembly.
2. Connect the electrical connectors to the HVAC control assembly.
3. Install the HVAC control assembly into the instrument panel, ensuring that the HVAC control assembly retaining tabs lock into place.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the HVAC control assembly retaining screws.
Tighten
Tighten the control assembly screws to 1.9 N.m (17 lb in).
5. Install the instrument panel accessory trim plate, refer to see Service and Repair
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.