Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000S10/T10 P/U 2WD V6-4.3L VIN WREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERSERVICE AND REPAIRTRANSMITTER SYNCHRONIZATION
2000 Chevrolet S10/T10 P/U 2WD V6-4.3L VIN W
Transmitter Synchronization
2000 Chevrolet S10/T10 P/U 2WD V6-4.3L VIN WSECTION Transmitter Synchronization
1. Resynchronization may be necessary due to the security method used by the RKE system. The transmitter does not send the same signal twice to the receiver.
2. The receiver will not respond to a signal that has been sent previously.
This prevents anyone from recording and playing back the signal from the transmitter.
3. Resynchronization may be necessary under the following conditions:
^ The battery in the transmitter is replaced. The battery in the transmitter is weak.
^ The battery in the vehicle has been in a low or no charge condition for an extended period of time.
4. In order to resynchronize the transmitter with the receiver, perform the following steps:
4.1. Stand within 1.5 meters (5 ft) from the vehicle.
4.2. Simultaneously press and hold the LOCK and UNLOCK buttons on the transmitter for 7 seconds.
The door locks should cycle in order to confirm resynchronization.
2. The receiver will not respond to a signal that has been sent previously.
This prevents anyone from recording and playing back the signal from the transmitter.
3. Resynchronization may be necessary under the following conditions:
^ The battery in the transmitter is replaced. The battery in the transmitter is weak.
^ The battery in the vehicle has been in a low or no charge condition for an extended period of time.
4. In order to resynchronize the transmitter with the receiver, perform the following steps:
4.1. Stand within 1.5 meters (5 ft) from the vehicle.
4.2. Simultaneously press and hold the LOCK and UNLOCK buttons on the transmitter for 7 seconds.
The door locks should cycle in order to confirm resynchronization.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.