Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000MALIBU V6-3.1L VIN JREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULESERVICE AND REPAIRREPAIR INSTRUCTIONSPASSWORD LEARN PROCEDURE
2000 Chevrolet Malibu V6-3.1L VIN J
Password Learn Procedure
2000 Chevrolet Malibu V6-3.1L VIN JSECTION Password Learn Procedure
In order for a theft deterrent vehicle to run, a password is communicated between the Body Function Control (BFC) and the Powertrain Control Module (PCM). If a PCM is replaced, the new PCM needs to learn the correct password of the vehicle. When the new PCM is installed, the EEPROM calibration is flashed into the new PCM and the vehicle will learn the new password upon the initial ignition ON cycle. If the BFC is replaced, the PCM needs to learn the new password from the BFC. The Password Learn Procedure is as follows:
1. Attempt to start the vehicle. The vehicle will stall.
2. Leave the ignition ON until the Theft System telltale turns OFF in approximately 10 minutes.
3. Turn OFF the ignition.
4. Attempt to the start vehicle. The vehicle will start on this attempt. The password is now learned.
Attempting to start the vehicle by bypassing the Theft Deterrent System or substituting parts without performing the password learn procedure may set a DTC P1631.
If no password is received a DTCs P1626, and P1631 may be set.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.