Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Seat Belt Indicator
2000 Chevrolet Malibu V6-3.1L VIN JSECTION Seat Belt Indicator
The seat belt indicator (red) will indicate the following conditions to the driver:
^ The seat belt switch is active.
^ The seat belt is unbuckled.
This occurs under the following conditions:
^ Upon ignition 1 transitioning from inactive to active
^ At any time while ignition 1 is active and the seat belt input should transition from inactive to active
Upon either transition, the seat belt indicator will illuminate steady for 20 seconds and then flash at 1 Hz for 55 seconds. The indicator will be OFF under the following conditions:
^ At the end of the 75 seconds
^ If at any time the seat belt input becomes inactive
^ If at any time Ignition 1 becomes inactive
^ The seat belt switch is active.
^ The seat belt is unbuckled.
This occurs under the following conditions:
^ Upon ignition 1 transitioning from inactive to active
^ At any time while ignition 1 is active and the seat belt input should transition from inactive to active
Upon either transition, the seat belt indicator will illuminate steady for 20 seconds and then flash at 1 Hz for 55 seconds. The indicator will be OFF under the following conditions:
^ At the end of the 75 seconds
^ If at any time the seat belt input becomes inactive
^ If at any time Ignition 1 becomes inactive
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.