Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000MALIBU V6-3.1L VIN JREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSINFORMATION BUSDESCRIPTION AND OPERATIONDATA LINK COMMUNICATIONS CIRCUIT
2000 Chevrolet Malibu V6-3.1L VIN J
Data Link Communications Circuit
2000 Chevrolet Malibu V6-3.1L VIN JSECTION Data Link Communications Circuit
DATA LINK CONNECTOR (DLC)
The Data Link Connector (DLC) terminal 2 contains the class 2 serial data link.
The DLC also provides a power source for the scan tool as follows:
^ Battery voltage at the DLC terminal 16 (circuit 1440).
^ Ground at terminal 4 (circuit 150) and terminal 5 (circuit 451).
CLASS 2 SERIAL DATA LINK
The class 2 serial data link allows the following modules to communicate with each other:
^ The body control module (BCM)
^ The electronic brake control module (EBCM)
^ The powertrain control module (PCM)
^ The inflatable restraint sensing and diagnostic module (SDM)
The class 2 serial data link allows a scan tool to communicate with the above modules for diagnostic and testing purposes.
The Data Link Connector (DLC) terminal 2 contains the class 2 serial data link.
The DLC also provides a power source for the scan tool as follows:
^ Battery voltage at the DLC terminal 16 (circuit 1440).
^ Ground at terminal 4 (circuit 150) and terminal 5 (circuit 451).
CLASS 2 SERIAL DATA LINK
The class 2 serial data link allows the following modules to communicate with each other:
^ The body control module (BCM)
^ The electronic brake control module (EBCM)
^ The powertrain control module (PCM)
^ The inflatable restraint sensing and diagnostic module (SDM)
The class 2 serial data link allows a scan tool to communicate with the above modules for diagnostic and testing purposes.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.