Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000MALIBU V6-3.1L VIN JREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSDESCRIPTION AND OPERATIONPCM CONTROLLED AIR CONDITIONINGA/C REQUEST SIGNAL
2000 Chevrolet Malibu V6-3.1L VIN J
A/C Request Signal
2000 Chevrolet Malibu V6-3.1L VIN JSECTION A/C Request Signal
PCM Controlled Air Conditioning Description:
This signal indicates to the PCM, that an A/C mode is selected at the A/C controller. The PCM uses this information to adjust the idle speed before turning on the A/C clutch. If this signal is not available to the PCM, the A/C compressor will be inoperative.
The A/C Request Signal (10) is a Class II Communication provided to the BFC and sent to the PCM through the Class II Communication circuit Under normal operating conditions, the following actions occur:
1. The PCM supplies a ground to the relay coil of the A/C compressor control.
2. The relay energizes.
3. Voltage is supplied to the A/C compressor clutch through the relay center fuse.
4. The A/C compressor clutch engages.
5. The compressor runs.
If the PCM determines that the engine load should be reduced, such as during full throttle conditions, the PCM de-energizes the relay of the A/C compressor control in order to disengage the compressor clutch. The de-energization occurs even though the voltage signal from the heater and A/C control is still present at the PCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.