Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2000MALIBU V6-3.1L VIN JREPAIR AND DIAGNOSISLIGHTING AND HORNSLAMP CONTROL MODULESERVICE AND REPAIR
2000 Chevrolet Malibu V6-3.1L VIN J
Lamp Control Module: Service and Repair
2000 Chevrolet Malibu V6-3.1L VIN JSECTION Service and Repair
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Disable the SIR system. Refer to Disabling the SIR System in SIR.
3. Remove the left sound insulator.
4. Disconnect the electrical connector.
5. Remove the bolts from the dimmer module (1).
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the bolts to the dimmer module (1).
Tighten
Tighten the screws to 4 N.m (35 lb in).
2. Connect the electrical connector.
3. Install the left sound insulator.
4. Enable the SIR system. Refer to Disabling the SIR System in SIR.
5. Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.